Model Engine Bearing Installation Easy installation of Model Engine Bearings.

Engine Analysis Program Measurement Use of a height guage for precise measurement.

Recent Tid-Bits Several findings from dyno testing and on-water testing.

Compression Ratios Re-visiting Compression Ratio.

How Our Dyno Works An "in depth" abstract on the workings of our Inertial Dyno by Brian Callahan.

Exhaust Timing A current look at our opinion on Exhaust Timing and Port Configuration.

Pipe Length #4 of 4 How to accurately determine Tuned Pipe Length - Part 4 and Summary

Pipe Length #3 of 4 How to accurately determine Tuned Pipe Length - Part 3

Pipe Length #2 of 4 How to accurately determine Tuned Pipe Length - Part 2

Pipe Length #1 of 4 How to accurately determine Tuned Pipe Length - Part 1

Bits & Pieces Bits and Pieces of information gathered from Dyno Testing.

After Run Lubrication of Model Engines A must read for all modelers!

Report on Building Our Inertial Dyno - Brian Callahan This paper is a Graduate Level paper prepared by Brian Callahan for his Graduate work at the University of Michigan. Easy to read and provides a lot of useful information.

Inertial Dynamometer This Tech Note discusses the recently completed Inertial Dynamometer.

Engine Blueprinting #5 (Final Assembly) This Tech Note discusses the clean up and final assembly of the engine.

Engine Blueprinting #4 (Rotor/Crank TIMING) This Tech Note discusses the timing of the Crank Induction or Rotor Assembly.

Engine Blueprinting #3 (Rotor/Crank FITTING) This Tech Note discusses the proper fitting and maintenance of the Rotor Assembly.

Engine Blueprinting #2 (The Exhaust Port - Shape & Timing) This Tech Note discusses the shape of the exhaust port and some other important information.

Engine Blueprinting #2 (Engine Measurement and Fitting) This Tech Note discusses to correct measurement methods, for the model engine, to input the data into "The Engine Analysis Software".

Combustion Chamber (Head) - Squish Velocity This article deals with squish velocity in technical terms.

Combustion Chamber (Head) - Shapes Several shapes of combustion chambers and their application.

Combustion Chamber (Head) - Squish Band This will show you the correct squish band shape, percentage, etc for our high nitro engines.

Tuned Pipes & How They Work Do you need a simple explanation of how tuned pipes work - then this is for you.

Engine Timing What is the correct timing for your engine? This will help you decide.

Engine - The Fit - Piston Part #2 of The Fit covering the Piston.

Engine - The Fit - Liner Part #1 of The Fit covering the Liner.

Engine - Compression Ratio This is the first Tech Article and maybe the place where you can make the most gain in performance. You MUST have The Engine Analysis Software for this to be meaningful to you.